Connect the USB receiver to your PC: drivers are installed automatically during software installation. ![]() The software will automatically start the communication.ġ.3.2 Wireless interface You need to bind the USB receiver to its wireless transmitter, the first time you use them. Locate the serial interface socket of the gas wiring harness (Superseal 4-ways connector) remove the plastic protection cap from the connector and connect the end of the interface. The drivers for USB interface are inside the CD-ROM, or in the zip package. To wake-up the ECU, ignition voltage shall be provided to red/white wire.ġ.3.1 USB interface Connect one end of the interface to a free USB port of your PC: the first time, a New Hardware Wizard will start. Note: the ECU communicates only when properly wired to battery and ground (red/black and black wires). 29ġ.3 Connection To connect to an ECU, use one of the available interfaces:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |